- microcurrent precision current sensor is a module capable to measure a current level up to 5A. This current sensor module is based upon the ZMCT103C IC. The module has 4 output pins and provides an analog output corresponding to the AC current passing through the wire.
Features
ZMCT103C is a small size, high accuracy module with some features and specifications mentioned below:
- Current Ratio: 5 A:5 mA
- Rated Primary Current at 50/60 Hz: 5 A
- Winding D.C. Resistance at 20 °C: 155 Ω
- Maximum Primary Current at 50/60 Hz: 20 A
- Transformer Turns Ratio: Np:Ns = 1000:1
- Isolation Voltage: 4500V
- Onboard sampling resistor, to drop the voltage to lower levels
- Operating Temperature: -40 to 85 °C
- Pin Length of the secondary coil (encapsulation) > 3mm
- Epoxy Encapsulation
Applications of ZMCT103C Current Sensor Module
Below are some of the applications of the ZMCT103C current sensor module:
- Measuring AC currents
- Monitor any current surges
- Ground fault detection
- Household electrical equipment
Pin Configuration for ZMCT103C Current Sensor Module
The ZMCT103C module has 4 pins, which are as follows:
- Ground (G)
- Ground(G)
- Signal Out
- VCC(+5V)
Package Includes
- 1 x ZMCT103C AC Current Sensor Module
ZMCT103C AC Current Sensor Module
- Current Ratio: 5 A:5 mA
- Rated Primary Current at 50/60 Hz: 5 A
- Winding D.C. Resistance at 20 °C: 155 Ω
- Maximum Primary Current at 50/60 Hz: 20 A
- Transformer Turns Ratio: Np:Ns = 1000:1
Category:
Project
Related products
-
Read moreThis sensor module has an MQ-8 as the sensor component and has a protection resistor and an adjustable resistor on-board. A sensitive material MQ-8 Hydrogen H2 Gas Sensor Module use in clean air low conductivity tin oxide (SnO2). When there is the environment in which the combustible gas sensor, conductivity sensor with increasing concentration of…
-
Read moreThis is a very easy to use low cost semiconductor Gas sensor Module with analog and digital output. This module uses MQ2 Smoke & Flammable gas sensor as a gas sensing element. It requires no external components just plug in Vcc & ground pins and you are ready to go. For Digital output the threshold…
-
Read more- Operating Voltage: 3V-5V
- High-resolution conversion of light intensity to frequency.
- Chip pins all has drawn for standard 100.
- Put the needle (2.54 mm).
- Mil-convenient for bitmap board.
- Programmable color and full-scale output frequency.
- Communicate directly with a microcontroller.
- Low-profile surface mount package.
-
Read moreACS712 Current Sensor Module – 5A can sense upto 5A of current flow. Sensing and controlling the current flow is a fundamental requirement in wide variety of applications, which includes over-current protection circuits, battery chargers, switching mode power supplies, digital watt meters, programmable current sources, etc. ACS712 Current Sensor Module – 5A is based on…