- This MPU6050 module with Triple Axis Accelerometer is based on MPU6050 chip from InvenSense. It sports a 3 Axis Accelerometer and 3 Axis Gyroscope along with an onboard Digital Motion Processor. The Digital Motion Processor is capable of processing complex 9 axis MotionFusion algorithms. The gyroscope is used to measure the rotational velocity or rate of change of angular position over time, along the X, Y and Z axis. The MPU6050 module with accelerometer uses the MEMS technology. The accelerometer measures acceleration over time. It can measure gravitational acceleration along 3 axis, using which we can calculate the angle at which sensor is positioned. So, by using, accelerometer and gyroscope data together, very accurate information on the position of the sensor can be obtained.
- Input Supply Voltage: 2.3V to 3.4V
- I2C digital output of 6 or 9 axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format
- Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000 °/sec (dps)
- Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
- Embedded algorithms for run-time bias and compass calibration. No user intervention required.
MPU-6050 3-Axis Accelerometer and Gyro Sensor
- Chip built-in 16bit AD converter, 16-bit data output
- Driver Chip: MPU6050
- Operating Voltage: 3-5V DC
- Communication: I2C/IIC Protocol
- Gyro Range: ± 250, 500, 1000, 2000 °/s
- Accelerometer Range: ± 2 ± 4 ± 8 ± 16 g
₹500.00
Out of stock
Category:
Sensor
Related products
-
Read moreThis is a very easy to use low cost semiconductor Gas sensor Module with analog and digital output. This module uses MQ4 Methane gas sensor as a gas sensing element. It requires no external components just plug in Vcc & ground pins and you are ready to go.For Digital output the threshold value can be…
-
Read moreFeatures:-
- The LM393, use of the wide voltage comparator
- Provide both digital and analog output
- Output LED indicator
- Compatible with Arduino
- TTL Compatible
- The sensor uses the high-quality FR – 04 double material, the large area of 5.5 * 4.0 CM
- Treatment of nickel plating and surface, have fight oxidation, electrical conductivity, and life has more superior performance
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 mA;
- With potentiometer sensitivity adjustment
- The output format: digital switch output (0 and 1) and analog AO voltage output;
- Has a fixed bolt hole, convenient installation
Specifications:-
- Operating Voltage (VDC) : 3.3 ~ 5
- Voltage Comparator : LM393
-
Read moreLDR Light Sensor Module LDR sensor module is used to detect the intensity of light. It is associated with both analog output pin and digital output pin labelled as AO and DO respectively on the board. When there is light, the resistance of LDR will become low according to the intensity of light. The greater…
